Instruction Manual

ManualsBrandsNewport Brass ManualsFor Home3-1776 Victoria

Congratulations on the purchase

of this Newport Brass product,

an excellent choice, that will give you

years of quality service and enhance

the look and style of your home.

ROMAN TUB 2 VALVE AND TRIM

INSTALLATION INSTRUCTIONS

Valve Model No's: 1-586

Trim Kit for Model No's: 1766, 1776

Summary of content (4 pages)

PAGE 1
ROMAN TUB 2 VALVE AND TRIM INSTALLATION INSTRUCTIONS Valve Model No's: 1-586 Trim Kit for Model No's: 1766, 1776 Congratulations on the purchase of this Newport Brass product, an excellent choice, that will give you years of quality service and enhance the look and style of your home.
PAGE 2
Rough in valve Installation Recommended Installation by a Professional Plumbing Contractor Note: Use Teflon tape or equivalent to seal all threaded joints. Warning:To prevent severe damage to valve body, any solder/braze process must be performed a min. of 4" from ports. 1. Install the quick connect spout shank through center hole of mounting surface. Secure with washer nut. See Fig. 1 2. Place washer nut on valve body. Insert body, (blue cold & red hot), through hole from below mounting surface. See Fig.
PAGE 3
1776 2" STEM LENGTH 1766 SERIES 2" TABLE 1 Trim Installation Note:To achieve desired handle rotational alignment, the cartridge MUST be tightened in a clockwise rotation only. (Cartridge Bonnet factory torque is 14-16 ft-lbs.) 4. Attach handle trim to valve.When possible, any adjustments for rotational alignment should be made to the valve body - not to the cartridge. (Note: Allow minimum spacing between handles and escutcheon/bonnet to prevent damage to the surface finish.
PAGE 4
LIMITED WARRANTY Brasstech, Inc. warrants to the original consumer residential purchaser ("Original Purchaser") that if a product in its; Newport Brass ®, Brasstech ®, Motiv ®, Plumbtrim ® or GINGER® lines of products ("Product") is confirmed upon inspection to be defective in materials or workmanship during the warranty periods described below, Brasstech, Inc. will, at its option, either repair or replace the Product with a similar current model of the Product.