Installation Guide

Rough in valve Installation

We recommended Installation of this product by a Professional Plumbing Contractor

Note: Use Teflon tape or equivalent to seal all threaded joints.

Warning: To prevent severe damage to valve body, any solder/braze process must be

performed a min. of 4" from ports.

It is strongly recommended that an access panel is built into the roman bath sur-

round. Access panels allow for ease of trim installation and future possible repairs.

Valve Installation

Place flange NUT (1) on valve BODY (2).

Insert BODY (2), (blue cold and red hot),

through hole from below mounting sur-

face.

Adjust and secure with flange NUT (3) so that

the top of valve stem is 1 3/4” above the

mounting surface. See Figure 1.

Spout Installation

Slide spout NIPPLE (3) through ESCUTCHEON

(5) and center hole of mounting surface.

Make sure ESCUTCHEON (5) is flush with

deck.

Note: Spacer (80125, not supplied) maybe

necessary to clear bath rim.

Secure into place with flange NUT (6). See

Figure 2.

Figure 1

Finished Deck

Ø1-1/4”

3/4” NPT

1- 3/4”

GNG-G45-006

Figure 2

Ø1-1/4”