Installation Sheet

NWP-1-532-16T 4/7/2016

Rev NC EN-2829H

Instruction Instructions

How to Install Newport Brass In-wall Trim

and Adjust 16 Tooth Handle Alignment

This instruction illustrates how to install Newport Brass In-wall Trim and use the Cartridge Adapter provided with the in-wall

valves to adjust angular alignment for in-wall product handles.

1. Spout Installation

1. Figure 1, determine the proper length of NIPPLE to connect SPOUT to OUTLET FITTING. Use a temporary

6” length x 1/2" NPT NIPPLE to connect them together. Measure the GAP between the Finish Wall and the SPOUT BASE

(including Base Ring where applicable). If length of the temporary NIPPLE is 6”, and the GAP is 1”, the proper length for the

NIPPLE is 5” (6 - 1=5”) to connect the SPOUT to OUTLET FITTING. Use plumbers tape or equivalent to seal all threaded

joints.

2. Handle Installation:

Note: If installed valve model is 1-532T or 1-500T, follow the installation instruction of the valves to adjust stiffness of stem

rotation by tightening or loosening the torque nut first. Handle should not rotate under its own weight. See installation instruction

NWP-532 for more details.

2A.Trim Cartridge Stem

1. Figure 2, install ESCUTCHEON/BONNET and BASE RING trim pieces onto CARTRIDGE ALL-THREAD NIPPLE flush

against Finished Wall. Mark the CARTRIDGE ALL-THREAD NIPPLE where excess needs to be trimmed.

2. Also in Figure 2, temporarily install HANDLE onto CARTRIDGE ADAPTER and measure DISTANCE between top of

ESCUTCHEON/BONNET and bottom of HANDLE. Record the DISTANCE measured.

Figure 2

ESCUTCHEON/BONNET

and BASE RING

CARTRIDGE ALL-THREAD NIPPLE

HANDLE

CARTRIDGE ADAPTER

GAP

Finish Wall

OUTLET FITTING

SPOUT

SPOUT BASE

NIPPLE

Figure 1

ADAPTER SCREW

CARTRIDGE STEM

PAGE 1
Instruction Instructions How to Install Newport Brass In-wall Trim and Adjust 16 Tooth Handle Alignment This instruction illustrates how to install Newport Brass In-wall Trim and use the Cartridge Adapter provided with the in-wall valves to adjust angular alignment for in-wall product handles. 1. Spout Installation 1. Figure 1, determine the proper length of NIPPLE to connect SPOUT to OUTLET FITTING. Use a temporary 6” length x 1/2" NPT NIPPLE to connect them together.
PAGE 2
3. Figure 3, disassemble HANDLE, ESCUTCHEON/BONNET, BASE RING, ADAPTER SCREW, and CARTRIDGE ADAPTER. Cut the SUM length from the 20 tooth CARTRIDGE STEM (SUM= DISTANCE +1/16”). Note: For some HANDLE styles, where a portion of the HANDLE base is inserted inside ESCUTCHEON/BONNET, additional CARTRIDGE STEM trim is needed to achieve desired aesthetic look. Trim (SUM = DISTANCE + 1/16”) CARTRIDGE STEM Figure 3 2B. Adjust Handle Alignment 1.