Manual

Open Towel Ring
Installation Instructions
Model No. 13-10,16-10, 29-10, 30-10
Recommended Installation by a Professional Contractor
1. Drill hole in wall at desired location using the appropriate drill size:
· Wood Screw (#6 x 2”) - use: 3/32" Drill
· Toggle Screw (6-32 x 3”) - use: 3/8" Drill
2. Fasten FLANGE (1) to wall using either WOOD/TOGGLE SCREWS (2). (See Fig. 1)
3. Position SPLINE (4) into FLANGE (1), per the Table below, at the proper height from mounting surface. Secure into place by
tightening SETSCREW (5). (See Fig. 2)
4.Temporarily place ASSEMBLY (6) onto BASE (1) to check alignment. If necessary, loosen lower screw on BASE (1) and adjust.
Retighten screw.
5.When applicable to model, place the ESCUTCHEON (7) onto FLANGE (1). Place ASSEMBLY (6) over POST (4) and against the
ESCUTCHEON (7). Secure into place by tightening the SETSCREW (5). (See Fig. 3).
5a.When applicable to model, locate the ESCUTCHEON (7) with O-RING (8) over FLANGE (1). Place ASSEMBLY (6)
over POST (4) and against the ESCUTCHEON (7). Secure into place by tightening the SETSCREW (5). (See Fig. 3a)
5b.When applicable to model, locate the ESCUTCHEON (7) over FLANGE (1). Insert NUT (8) into BONNET (9) and attach to
POST (4). Place ASSEMBLY (6) over POST (4) and against the NUT (8). Secure into place by tightening the SETSCREW
(5). (See Fig. 3a)
Fig. 1
Fig. 3
7
6
2
1
5
4
MODEL 13- 16- 29- 30-
STEM HT. 2 3/16" 2 3/16" 2” 2 5/16”
Fig. 3a
Fig. 3b
Post Height
See Table
Fig. 2
5
4
1
7
6
1
5
4
7
6
1
5
4
1
8
8
9