Specification Sheet

t: 949.417.5207 l www.newportbrass.com
©2018 Brasstech, Inc.
Cold Water Dispenser
Features
• Solid brass construction
• Quarter-turn washerless ceramic disc valve cartridge
• ADA compliant contemporary cold lever handle
• Spout assembly with integral supply hoses
• 6-5/8” (16.8 cm) spout height at outlet
• 4-3/4” (12.1 cm) spout reach (c-c)
• For single hole configurations
• 1 gallon (3.6 liters) per minute maximum flow rate*
Codes / Standards Compliance
Meets or exceeds the following at date of manufacture:
• ASME A112.18.1/CSA B125.1
• IAPMO/cUPC
• IPC
• NSF 61
• NSF 372
• ADA (Handle Only)
• Energy Policy Act of 1992
• All applicable US Federal and State material regulations
Colors / Finishes
• 10B: Oil Rubbed Bronze
• 15: Polished Nickel
• 15S: Satin Nickel - PVD
• 26: Polished Chrome
• Other: Refer to the Newport Brass
catalog for additional color/finish options.
3170-5623
ADAMS
15S
10B 26 Other15
Specied Model
Model Description Colors | Finishes
3170-5623 Cold Water Dispenser
20-280 Integrated Air Gap Base N/A
Page 1 of 2 Spec_3170-5623
Product Specication Add “Color / Finish” sufx to Model number, below.
The Cold Water Dispenser Faucet shall be made of solid brass construction. Faucet shall incorporate a spout assembly with integral supply
hoses and feature a quarter-turn washerless ceramic disc valve cartridge. Faucet shall incorporate an ADA compliant contemporary cold
lever handle design. Cold Water Dispenser Faucet shall have a 1 gallon (3.6 liters) per minute maximum flow rate and accommodate single
hole configurations. Product shall incorporate a 6-5/8” (16.8 cm) spout height at outlet and a 4-3/4” (12.1 cm) spout reach (c-c). Cold Water
Dispenser Faucet shall be Newport Brass Model 3170-5623/____ .[Integrated Air Gap Base shall be Newport Brass Model 20-280/____].
** The use of an air gap is required for dispenser faucets drawing from a reverse osmosis filtration system. The Integrated Air Gap Base
(6-027) affords the functionality of a separate air gap within the design of the product as depicted. Failure to specify the Integrated Air
Gap Base (20-280) will result in a product constructed using the standard base (no internal air gap).
A Water Dispenser flow rate of approximately 1 gpm or less is
typical but will vary depending on installation specifi c factors
including in-line water pressure and water fi ltration system.