Specification Sheet
t: 949.417.5207 l www.newportbrass.com
©2018 Brasstech, Inc.
Hot and Cold Water Dispenser
Features
• Solid brass construction
• Quarter-turn washerless ceramic disc valve cartridges
• Contemporary lever handle design
• Spout assembly with integral supply hoses
• Spring-loaded, normally closed lever handle
• 6-1/4” (15.9 cm) spout height at outlet
• 4” (10.2 cm) spout reach (c-c)
• For single hole configurations
• 1 gallon (3.6 liters) per minute maximum flow rate*
Codes / Standards Compliance
Meets or exceeds the following at date of manufacture:
• ASME A112.18.1/CSA B125.1
• IAPMO/cUPC
• IPC
• NSF 61
• NSF 372
• Energy Policy Act of 1992
• All applicable US Federal and State material regulations
Colors / Finishes
• 10B: Oil Rubbed Bronze
• 15: Polished Nickel
• 15S: Satin Nickel - PVD
• 26: Polished Chrome
• Other: Refer to the Newport Brass
catalog for additional color/finish options.
3200-5603
JETER
15S
10B 26 Other15
Specied Model
Model Description Colors | Finishes
3200-5603 Hot and Cold Water Dispenser
5-036 Point-of-Use Water Heater (115V, 140°F to 190° range) N/A
Page 1 of 2 Spec_3200-5603
Product Specication Add “Color / Finish” sufx to Model number, below.
The Hot and Cold Water Dispenser Faucet shall be made of solid brass construction. Faucet shall incorporate a spout assembly with integral
supply hoses and feature quarter-turn washerless ceramic disc valve cartridges. Faucet shall incorporate a contemporary lever handle design
and feature a spring-loaded, normally closed hot lever mechanism. Hot and Cold Water Dispenser Faucet shall have a 1 gallon (3.6 liters) per
minute maximum flow rate and accommodate single hole configurations. Product shall incorporate a 6-1/4” (15.9 cm) spout height at outlet and
a 4” (10.2 cm) spout reach (c-c). Hot and Cold Water Dispenser Faucet shall be Newport Brass Model 3200-5603/____ . [Point-of-Use Water
Heater shall be Newport Brass Model 5-036].
A Water Dispenser flow rate of approximately 1 gpm or less is
typical but will vary depending on installation specifi c factors
including in-line water pressure and water fi ltration system.