Installation & Assembly

INSTALLATION INSTRUCTIONS

KITCHEN FAUCET

Model No: 940, 941

Congratulations on the purchase

of this Newport Brass product,

an excellent choice, that will give you

years of quality service and enhance

the look and style of your home.

PAGE 1
INSTALLATION INSTRUCTIONS KITCHEN FAUCET Model No: 940, 941 Congratulations on the purchase of this Newport Brass product, an excellent choice, that will give you years of quality service and enhance the look and style of your home.
PAGE 2
Note: If installing faucet to a stainless steel rim, an under-mount support, (e.g. wood, appropriate size x 1/2” thick), should be utilized. 1. Before installing the faucet, flush the hot and cold lines to eliminate any dirt that may have accumulated in the pipes of the home. 2. The through hole in the sink or countertop should be between 11/4" to 1-1/2". If the sink has three holes, use a cover plate to cover extra holes (PN: 102 is not supplied with the faucet and must be ordered separately). 3.
PAGE 3
Troubleshooting and Maintenance Difficult to rotate spout Remove handle assembly by unscrewing escutcheon CCW. Apply plumbers (non-petroleum based) grease to the o-rings on valve body (91096). Difficult to lift and/or rotate handle Apply plumbers grease to handle swivel ball under escutcheon. Also an over tightened locknut (10357) will cause increased pressure on the ceramic disk inside of the cartridge. Tighten locknut to a torque of 8-10 ft-lbs.