User`s manual

1. Do not rotate the arm over the edge of desk to
avoid the arm falls.(Fig.1)
2. Do not place the arm in a shaking environment .
3. Do not remove any part except handle, rubber
cap and bolt as illustrated.(Fig.2)
4. Do not put your fingers in the space of knobs to
avoid getting hurt.(Fig.3)
5. Please maintain all operation under room
temperature.
6. Do not place the other stuff on the surface of the
arm.
7. Do not place the panel weighted over 8 kgs.
8. Do not adjust the monitor with single hand.
(Fig.4)
9. Be sure to secure the arm to the panel with 4
screws tightly.(Fig.5)
10. Be sure to adjust the arm in a vertical status
after the job done to avoid the resiliency exhaustion
of gas cylinder.(Fig.6)
11.Cable cover is restricted to hold two 8mm &
Fig.1
Fig.2
Fig. 4
Fig.6
Fig.3
Fig.5
11 Safty Notes: