User manual

First Key Second Key Third Key Command
SCROLL LOCK SCROLL LOCK 1 Switch to First PC
SCROLL LOCK SCROLL LOCK 2 Switch to Second PC
SCROLL LOCK SCROLL LOCK Switch to Previous PC
SCROLL LOCK SCROLL LOCK Switch to Next PC
SCROLL LOCK SCROLL LOCK 0 Go to Auto-Scan mode
Keyboard Hot Key commands
To send Hot Key commands to the NS-211K unit, press the
SCROLL LOCK Key twice within 2 seconds. Now you will be
given a beep as confirmation, now press a command key to
give a Hot Key command. The following commands are
supported:
In Auto-Scan mode the NS-211K unit will switch to the next
computer every 10 seconds. This means that all computers
will be shown on the monitor in a row, starting with the first
computer after the last one has been shown.
To prevent errors, there is no mouse or keyboard control, in
this mode. Erratic input will result if the mouse is moved or if a
keyboard key is pressed while the unit switches to the next
computer.
To exit Auto-Scan mode press the SPACE BAR. The NS-211K
will stop at the last computer shown.
Using the NS-211K
The NS-211K switch unit provides two ways to select which
computer is the active system. Use either the Select button
on the unit,or make use of the keyboard Hot key commands.
You may notice that the mouse can not be used for around 2
seconds when the NS-211K switches to another computer.
This is normal and is caused by the synchronization that
makes sure the mouse operates properly.
Select button
Pressing the Select button cycles through computers 1~2
Port.
Port Status
7 8
NS-211K NS-211K