Specifications

First Key Second Key Third Key Command

Port Status

In Auto-Scan mode the NS-411K unit will switch to the next

computer every 10 seconds. This means that all computers will be

shown on the monitor in a row, starting with the first computer after

the last one has been shown.

To prevent errors, there is no mouse or keyboard control in this

mode. Erratic input will result if the mouse is moved or the

keyboard key is pressed while the unit switches to the next

computer.

To exit Auto-Scan mode press the SPACE BAR. The NS-411K will

stop at the last computer shown.

Using the NS-411K

The NS-411K switch unit provides two ways to select which

computer is the active system. Use either the Select button on

the unit, or make use of the keyboard Hot key commands.

You may notice that the mouse can not be used for around 2

seconds when the NS-411K switches to another computer. This is

normal and is caused by synchronization that makes sure the

mouse operates properly.

Select Button

Pressing the Select button cycles through computers 1 ~ 4 Port

Keyboard Hot Key commands

To send Hot Key commands to the NS-411K unit, press the

SCROLL LOCK Key twice within 2 seconds. Now you will be given

a beep as confirmation, now press a command key to give a Hot

Key command. The following commands are supported:

SCROLLLOCK

Switch to First PC

Switch to Second PC

Switch to Third PC

Switch to Fourth PC

Switch to Previous PC

Switch to Next PC

Go to Auto-Scan mode

NS-411K NS-411K

-7- -8-