Installation Guide

Deck-A-Floor PRO Board
Installation:
1. Take the first UltraShield composite board and enter the
one side of the boards groove into the DAF PRO clip.
2. Then line of the ends and board with the frame and use
your body weight, foot, or mallet to push the other boards
groove into the clip.
3. A snapping sound will be heard which will signify that the
board has now been clipped into the clip
4. Repeat steps 1-3 until all boards are installed.
Note: A rubber mallet can be used in place of your foot to
snap the boards into place. One should NEVER use a
metal hammer or sharp object to snap the boards into
place. Figure 24
Figure 25 Figure 26