Installation Guide

Deck-A-Floor PRO Gap Spacer
Usage:
1. When installing boards that butt up at sister joists use
the gap spacer to give yourself the correct spacing.
2. First install one of the boards by lining it up with your
frame as show in Figure 27.
3. Hold the gap spacer in place and take the board and
put it against the gap spacer so you are sandwiching
the gap spacer with two boards as shown in Figure 28.
4. Finish by installing the board and then pull out the gap
spacer and repeat steps 2-3 until are boards are
installed.
Figure 27
Figure 28