Installation Guide

Figure 6
Figure 7 Figure 8 Figure 9
Deck-A-Floor PRO Clip Cont.
**Cutting the Dovetail Connections if Necessary**
1. As seen in Figure 6 you can see that the clips edge is
not entirely flush with our frame, therefore, we will
need to cut off the dovetail connections to get it
completely flush.
2. First take a DAF PRO Clip and position it upright and
take a Stanley knife or shears and cut the dovetail
connections off as shown in Figure 7.
3. After cutting you can see in Figure 8 that the side can
now be completely flush with the frame.
Note: Both sides of the clips connections can be cut
if necessary using the same procedure listed above.
You can see both sides of the clip in Figure 9.
Continued on the next page.