Installation Guide

Figure 13
Figure 14
Deck-A-Floor PRO Clip Cont.
Continuing Installation:
2. After the line is marked use a chalk line to
replicate this across the rest of the frame. A chalk
line doesn’t have to be used if your frame is
already lined up.
3. Begin installing the first DAF PRO clip by using
two M4 x 30 screws or 12d nails as shown in
Figure 13.
Note: It is important to put your hands on the
side of the clips as these will ensure that the clip
is straight when you are installing.
4. Next, take the next DAF PRO clip and use the
interlocking ends to connect the first DAF PRO
clip to the second one as shown in Figure 14.
5. Repeat steps 3-4 until the entire first joist is filled
with DAF PRO clips.
6. Repeat step 5 until each joist has DAF PRO clips.
Note: It is important to ensure that all the clips
are lined up, if not the final look will be affected.
Continued on the next page.