Use and Care Manual

UltraShield
TM
Caring and Cleaning Guide
Cleaning the Area
Option 3: Household/Laundry Detergent
1. Take the detergent and apply it on the boards
as shown in Figure 9.
2. Then take water and pour it over the
detergent and rub it into the boards and allow
it to sit for at least 5 minutes as shown in
Figure 10.
3. After allowing the detergent/water sit for 5
minutes begin scrubbing with the steel wool
in the direction of the wood grain.
Note: When using steel wool only scrub in
the direction of the wood grain never ever
scrub against the wood grain.
4. After scrubbing for 1-2 minutes rinse the area
with water and dry with a towel to see the
results as shown in Figure 11.
Note: It might take multiple times scrubbing
the board in order to get the mineral deposit
off the surface.
Also, quicker results may be seen if you
continuously scrub while adding toilet bowl
cleaner and water.
Figure 8
Figure 9
Figure 11Figure 10