Installation Guide

Decking Installation Guide / v20200731US 12

DIAGRAM 11

DIAGRAM 12

Bullnose Installation

Use the table on the previous page to determine the center to center spacing for the bullnose prole.

A minimum of four (4) stringers are required when installing the bullnose prole.

Overhang on a stair tread should not exceed more than 5/8 inch.

Starting Accessory Installation:

First, determine how many boards your stair is going to take to finish (with clips) and then you can

start to measure where the TC-5/MG-3 (SC-25) starting clip will go. Use a white chalk line (NEVER USE

COLORED CHALK) to ensure that all TC-5/MG-3 (SC-25) starting clips are lined up on each joist.

Note: The bullnose prole can only cantilever 5/8 inch. If the bullnose prole cantilevers more than this,

the warranty will be voided.

Bullnose Installation:

Now take the bullnose prole and place it right over all the TC-5/MG-3 (SC-25) starting clips and

push down as show in Diagram 12.