Installation Guide

Decking Installation Guide / v20200731US 19
3
The fascia board will be installed into the block wood and through the joist.
Note: NEVER install the fascia by drilling into the decking ALWAYS install the fascia into the
joist and ALWAYS pre-drill the fascia board.
1
Place the end cap infront of the hollow boards holes and push in as shown in Diagram 32.
Note: A mallet could be used as well to push in the end caps.
End Cap Installation
2
First, pre-drill the holes for the fascia board with the Deckfast Fascia Tool. The Deckfast Fascia Tool must
be used in order to ensure the correct nish for the fascia boards.The tool can be found here at: http://
www.starbornindustries.com/deckfast-fascia-product. The fascia boards must then be xed using our
composite fascia color head screws which are #9 1-7/8".
1
Fascia boards with a thickness of less than or equal to 25/64 inch need to be installed on 12 inches
on centers to prevent warping or buckling. Fascia boards with a thickness greater than 10 mm can be
installed on 16 inches on centers. All fascias need to use two screws 1” 1/2 away from the ends as shown
in Diagram 31 regardless of the thickness.
Fascia Board Installation
Installing against the width and length of decking
DIAGRAM 31
12 inches