Use and Care Manual

Cleaning the Area
Option 1: Vinegar (Continued)
7. After drying the effected boards should look
brand new. As you can see in Figure 5 you
can see the difference between the area
cleaned versus not cleaned.
Option 2: Toilet Bowl Cleaner
1. Take the toilet bowl cleaner and apply it onto
each effected board as shown in Figure 6.
2. Then take water and pour it over the effected
boards and rub together the toilet bowl
cleaner and water and allow it to sit on the
boards for at least 5 minutes as shown in
Figure 7.
3. After 5 minutes take the steel wool and scrub
in the direction of the wood grain for about
1-2 minutes.
Note: When using steel wool only scrub in
the direction of the wood grain never ever
scrub against the wood grain.
4. After scrubbing take water and rinse the area
and dry with a towel to see the results. The
results are shown here in Figure 8 you can
see the difference between cleaning versus
not cleaning.
Note: It might take multiple times scrubbing
the board in order to get the mineral deposit
off the surface.
Also, quicker results may be seen if you
continuously scrub while adding toilet bowl
cleaner and water.
UltraShield
TM
Caring and Cleaning Guide
Figure 5
Figure 6
Figure 7