Installation Guide

UltraShield
TM
Decking Installation Instructions
Hidden Fasteners
Installing hidden fasteners with UltraShield
TM
is
relatively simple and quick compared to regular lumber.
Before you installing hidden fasteners into
UltraShield always figure out which type of style/
pattern you will be doing for your deck. Plan out
where the locking and moving clips will be going on
each joist. See page 10 & 11 for more information.
There are two options when installing hidden fasteners
into UltraShield:
Option 1: T-Clip System
1. First slide the TC-1 and TC-2 clips into the groove of
the boards with screws facing up.
2. After getting all the TC-1 and TC-2 clips into position
take your next board and slide them into the
fasteners as shown in Diagram 6 & 7.
3. Next screw down the TC-1 and TC-2 clips from the
top
4. Repeat steps 1-3 until the deck is finished.
Note: For an easier install with the T-Clip System try
first pushing all the boards together and then
coming back in and sliding the clips into the
grooves and then into place on each joist as shown
in Diagram 8
(Continued on the next page)
1
1
1
6
Diagram 6
Diagram 7
Diagram 8