Installation Guide
Decking Installation Guide / v20170808 17
DIAGRAM 37
DIAGRAM 38
DIAGRAM 40 DIAGRAM 41
1
Fascia boards with a thickness of less than
or equal to 25/64 inch need to be installed
on 12 inches on centers to prevent warping
or buckling. Fascia boards with a thickness
greater than 10 mm can be installed on 16
inches on centers. All fascias need to use two
screws 1” 1/2 away from the ends as shown in
Diagram 39 regardless of the thickness.
6
The final look should be like the below
Diagram 38.
Note: The locking clip is in the middle of
Diagram 38 to show the expansion and
contraction is happening in both directions.
For more information on how to install the
locking clips and their placement, check
page 8 of this installation guide.
Fascia Board Installation
Installing against the width and length of
decking
DIAGRAM 39
12 inches
2
First, pre-drill the holes for the fascia board.
The fascia board should be drilled with bigger
holes or routed to allow for expansion and
contraction and fixed either at either end or
in the middle as shown in Diagram 41. When
xing the bigger holes, it is recommended to
use washers.
3
The fascia board will be installed into the the
block wood and through the joist.
Note: NEVER install the fascia by drilling
into the decking ALWAYS install the
fascia into the joist and ALWAYS pre-drill
the fascia board.
5
Repeat steps 1-4 until complete.
1
Place the end cap infront of the hollow boards
holes and push in as shown in Diagram 40.
Note: A mallet could be used as well to
push in the end caps.
2
The nal nish should look like Diagram 41
below.
Note: A dab of silicon can be used on the
end cap or inside the holes of the board
in order to secure the end caps beer.
End Cap Installation