Installation Guide

Deck Tile Installation Guide / v20170809 1
IMPORTANT:
Read All Sections Before You Start
For the most up to date information, please visit our website @ www.newtechwood.com
Prior to installing any composite product, it is recommended that you check with local building codes
for any special requirements or restrictions. The diagrams and instructions outlined in this guide are
for illustration purposes only and are not meant or implied to replace a licensed professional. Any
construction or use of NewTechWood must be in accordance with all local zoning and/or building codes.
The consumer assumes all risks and liability associated with the construction and use of this product.
Safety
When dealing with any type of construction project, it is necessary to wear appropriate safety equipment
to avoid any risk of injuries. NewTechWood recommends but is not limited to the following safety
equipment when handling, cutting, and installing the Deck Tile: gloves, a respiratory protection, long
sleeves, pants, and safety glasses.
Tools
Standard woodworking tools may be used. It is recommended that all blades have a carbide tip.
Environment
A clean, smooth, at, and strong surface is needed to install Deck Tile correctly. Please check with local
building codes before ever installing any type of decking. If installation does not occur immediately,
NewTechWood's products need to be put on a at surface at all times. Never ever should it be put on a
surface that is NOT at.
Static
Static can also be more prevalent in areas that are of higher altitude because the humidity is lower. For
these areas, be careful of using conducive objects such as metal railing and chairs as static shocks might
occur more often. A potential way to lower the amount of static shocks occurring is to apply Staticide
(www.aclstaticide.com) on your deck or use anti-static mats before doorways. NewTechWood’s products
have been tested against EN 1815 - Assessment of Static Electrical Propensity and have received values
under the maximum standard of 2kV.
Layout
Before installing the Deck Tile, always make sure that you are installing it on a clean smooth at surface.
The Deck Tile CANNOT be installed on places such as dirt, soil, or raised structure it must be laid out on
a at solid surface.