Instructions / Assembly

UltraShield
TM
QuickDeck Installation Instructions
Cutting
Cutting the UltraShield Quick is simple and
quick just remember when cutting that you need
a carbide tip blade.
Corners/Edges
1. First measure the corner/edge that will need
to be cut as shown in Diagram 12.
2. Next, take the piece and redraw the measured
area that you will be cutting onto the
QuickDeck.
3. Then, take your QuickDeck and cut either with
a circular saw, table saw, hand saw, or jigsaw.
Always remember to use a carbide tip blade
on these tools as shown in Diagram 13 & 14.
The final piece we cut for this corner is shown
in Diagram 15.
Note: Before cutting always turn the Quick
Deck over and make sure that the cut lines
you have marked on the QuickDeck do not
cross over any screws on the back. Never
ever should you be cutting through the
screws. If your lines cross over these screws
first unscrew the screws and then cut the
QuickDeck.
4. Now, take the QuickDeck and sand down the
sides of the cuts to make them smooth as
shown in Diagram 16.
5. Finally, put the finished piece in its corner/
edge as shown in Diagram 17.
6. Repeat steps 1-5 for any other corners/edges.
!"#$%#&'()
!"#$%#&'(*
,