Installation Guide

Bullnose Installation
Use the table on the previous page to determine
the center to center spacing for the bullnose
profile.
A minimum of four (4) stringers are required
when installing the bullnose profile.
Overhang on a stair tread should not exceed
more than 5/8inch.
Diagram 13
Diagram 14
Starting Accessory Installation:
1. First determine how many boards your stair is
going to take to finish (with clips) and then you
can start to measure where the TC-5 starting clip
will go. Use a white chalk line (NEVER USE
COLORED CHALK) to ensure that all TC-5
starting clips are lined up on each joist.
Note: The bullnose profile can only cantilever
5/8 inch. If the bullnose profile cantilevers
more than this the warranty will be void.
Bullnose Installation:
1. Now take the bullnose profile and place it right
over all the TC-5 starting clips and push down as
show in Diagram 14.
2. Now that the TC-5 starting clips are inside the
underside of the bullnose, the final step is to
push forward to ensure that it secured into place.
Diagram 15
v20151224