Installation Guide

Bullnose Installation Continued:
3. Now take the next board and have it situated
behind the bullnose profile as shown in Diagram16.
Diagram 16
4. Slide in the clips into the two grooves and glide
them along until they are on their respective joists
and then screwing down onto the joists as shown
in Diagram 17 and 18.
Diagram 17
5. Finally, finish your last board by face fixing into
the board at every joist as shown in Diagram 19.
Note: Remember to pre-drill before face fixing
into the board. Also face fixing must happen at
a 90 degree angle and must be at least 1” 1/2 by
1” 1/2 from the ends and the width of the board.
Diagram 18
Diagram 19
v20151224