Installation Guide

Fascia Board Installation
Installing against the width and length of decking
1. The fascia should be installed on the rim board of the frame. The fascia should be installed as shown in
Diagram 32. The distance between screws must be less than or equal to 12 inches. Two screws must be
used 1” 1/2 away from the ends
2. First pre-drill the holes for the fascia board. The fascia board should be drilled with bigger holes or routed to
allow for expansion and contraction and fixed either at either end or in the middle as shown in Diagram 32.
When fixing the bigger holes it is recommended to use washers.
3. The fascia board will be installed into the the block wood and through the joist.
Note: NEVER install the fascia by drilling into the decking ALWAYS install the fascia into the joist and
ALWAYS pre-drill the fascia board
v20151224
Diagram 32
300 mm
12 inches