Installation Guide

Siding Installation Guide / v20190507US 30
DIAGRAM 55
DIAGRAM 58
DIAGRAM 57
3
Now x face the cut pieces to the tops of
the joists as shown in Diagram 57.
Note: Always pre-drill before screwing
unless using composite screws designed
for non pre-drilling. The distance
between each screw should be no more
than 12 inches (300 mm) center to center.
2
Cutting out a notch at both ends might be
required to ensure that it fits around the
joist as shown in Diagram 56.
1
Take the F trim and cut them to the length
of the top of the cladding structure you are
installing on as shown in Diagram 55.
1
First measure the distance between the
ceiling to the second to last Siding board as
shown in Diagram 58.
F Trim
Siding Board
Finishing the last board
12
After completing all walls you should have
the following installation as shown in
Diagram 54.
DIAGRAM 54
Option 1:
Option 2:
DIAGRAM 56