User Manual

Page | 178
DSK layers automatically
appear temporarily on the
Preview and (M/E Preview)
monitors when the Position
panel is open (regardless
layer display options).
This frees you to tinker with
positioning without the
result appearing on output
prematurely.
Click and drag on the Position button to relocate the associated DSK layer vertically
or horizontally within the frame. Dragging left or right directly on either of the two
nearby numeric controls adjusts the position on a single axis only.
Hint: You can also constrain mouse actions to one axis by holding down the Ctrl key
before dragging.
In similar fashion, drag the pointer over the Rotation button
with the left mouse button depressed to turn the overlay source
on three axes as follows:
 Drag left/right to rotate the source about the Y (vertical)
axis.
 Drag up/down to rotate the source about the X
(horizontal) axis.
 Drag while holding Alt down to rotate
about the Z axis.
 Drag on a single numeric slider below, or
hold down Ctrl while dragging to constrain
rotation to one axis.
Dragging the cursor on the
Scale button (magnifying glass)
affects the size of the overlay.
When Keep Aspect is enabled,
dragging in any direction affects
scale equally on both axes.
Otherwise, dragging vertically
on Scale changes the height, while dragging
horizontally affects width.
Hint: If you click a numeric field (or right-click it), you can type a value into the gadget
using the keyboard – press Enter to complete the editing action, or Esc to cancel it).
FIGURE 166
FIGURE 167