User Manual

Page | 397
22.6.7 LEVEL CONTROL
As you would expect, adjusting the position of a given fader modifies
the volume level of the corresponding control in TriCaster’s Audio
Mixer.
For example, pushing the control surface fader labeled Audio1 A raises
the volume for the source labeled Audio 1 A in TriCaster’s Audio Mixer.
22.6.8 KNOB SET SELECTORS
A set of Knob Set selectors (Figure 374) runs vertically down the left side of Artist
mix (left of the first fader). Essentially, these are mode buttons that select which
audio attributes are governed by the eight ‘knob sets’ – that being one OLED display
group and the knob immediately beneath it, along with the two buttons to the left of
the knob (SEL and ON) in that set (see Figure 375).
Note: The FLIP/CHAN button in this group is a special case, and can be
selected even when another mode is active. Generally speaking, you will
very likely find it best to leave this button off except for certain operations –
notably for EQ and Mic Trim adjustments. We’ll discuss these exceptions
in context as we go along.
The default Knob Set mode is PAN. For the most common production
operations, this is the mode you will choose. In fact, at the simplest
level, once you have configured the Artist Mix channels to take any SDI
sources into account, you could likely be forgiven for never using
another Knob Set mode.
Generally speaking, the alternative Knob Set modes provide access to
deeper audio configuration options and settings. We’ll provide the
details of their use in context as we go along.
FIGURE 373
FIGURE 374