User Manual

Page | 34
 (8-input models only) Output 3 can be used to mirror either of the two
primary outputs, or transmit a completely different source in its original
format.
1. Connect downstream video devices to the appropriate output connectors in the
VIDEO OUT section, whether SDI, Component, Y/C (BNC) or Composite (TriCaster
410 supports SDI output only). Please note that the latter two analog formats
may require RCA (cinch plug) or S-video (4 pin mini-DIN) to BNC adapters, and
also that both of these connection options support output at SD resolution only.
a. SDI – Attach SDI connectors to BNC connectors in the VIDEO OUT group
labeled 1-(2 or 3).
Hint: If your equipment supports SDI, this is the best alternative. Note that
the following analog output options are not supported by TriCaster 410.
b. Component – Attach your device to the second, third and fourth BNC
connectors (Y, Pb and Pr).
c. Y/C – If your S-Video equipment and cabling has the usual 4-pin mini-
DIN connectors, you will need an ‘S-Video to dual BNC’ adapter.
i. Attach the Y (luma) connector of your device to the second
analog BNC connector row (labeled Pb at far left in the VIDEO IN
group).
ii. Attach the C (chroma) connector to the third analog connector
(labeled Pr).
d. Composite – Attach the device’s connector to the first (top) analog
connector (just above the pair labeled Y/C).
2. Connect TriCaster’s audio outputs:
a. Analog audio – Connect external audio devices to the connectors in the
AUDIO OUT section.
8-input TriCasters offer two pairs of four audio output connectors: