User Manual

Page | 41
For standard definition monitoring,
several different connection types
continue in service. These include
Composite, Y/C (also known as ‘S-Video’)
and – at the upper end of the analog
quality range – Component. (SDI
provides a digital output option, and is
the only alternative offered by TriCaster
410.)
To connect an analog standard
definition monitor (not supported by
TriCaster 410), you must specify its connection type in the Output Configuration
panel.
Note that analog connections for LiveText™ output (as well as the SpeedEDIT™ Add-
On, when installed) are pre-defined (see Chapter 21 for details). Let’s take a closer
look at configuration options.
FIGURE 22
1. Move your mouse pointer over the large Program Output monitor on the
Live Desktop.
2. Click the Configure button (gear) that appears at right below the monitor
pane (Figure 22) to open the Output Configuration panel.
This panel provides two tabbed panes, the first of which is labeled Output. This is
where the video signals present on each of TriCaster’s video outputs, as well as the
HDMI, Network and Stream outputs and Display ports (TriCaster 8000 only) are
configured. There are various decisions to make for each output:
 What video source do you want to assign to that output?
FIGURE 21 (TriCaster 8000 shown)