User's Manual

User’s Manual
Light Industrial AP ENGLISH
11
Copyright © NEXCOM, INC.
2.3 Hardware Installation
Please follow the steps mentioned below to install the hardware of IWF2220:
Step 1. Place the IWF2220 at the best location. The best location is usually at the center of your intended
wireless network.
Step 2. Connect the IWF2220 to your network device. Connect one end of the Ethernet cable to the Uplink
port of IWF2220 and the other end of the cable to a switch, a router, or a hub. IWF2220 is then
connected to your existing wired LAN network.
Step 3. There are two ways to supply power to IWF2220
a) Connect the DC power adaptor to the IWF2220 power jack socket.
b) The IWF2220 Uplink port is capable of receiving DC currents. Connect a (IEEE 802.3at-
compliant) PSE device (e.g. a PoE-switch) to the Uplink port of IWF2220 with the Ethernet cable.
Now, the Hardware Installation is complete.
 Please use only the power adapter supplied with the package. Using a different power
adapter may damage this system.
 To verify the wired connection between the AP and your switch / router / hub, please also
check the LED status indicator of the respective network devices.