User's Manual

User’s Manual
Light Industrial AP ENGLISH
78
Copyright © NEXCOM, INC.
Table 3 Status Page's Organizational Layout
Item
Description
System
System Name
The system name of the Access Point.
Firmware Version
The current firmware version of the Access
Point.
Build Number
The current firmware build number of the
Access Point.
Location
The location of the Access Point.
Site
The site of the Access Point.
Device Time
The system time of the Access Point.
System Up Time
The time that the system has been in
operation.
LAN Interface
MAC Address
The MAC address of the LAN Interface.
IP Address
The IP address of the LAN Interface.
Subnet Mask
The Subnet Mask of the LAN Interface.
Gateway
The Gateway of the LAN Interface.
Radio Status
MAC Address
The MAC address of the RF Card.
Band
The RF band in use.
Channel
The channel specified.
Tx Power
Transmit Power level of RF card.
AP Status
Profile Name
The profile name of AP.
BSSID
Basic Service Set ID.
ESSID
Extended Service Set ID.
Security Type
Security type of the Virtual AP.
Online Clients
The number of online clients.
Tunnel
The status of the used Tunnel.
IPv6
Status
Enabled/ Disabled.
CAPWAP
Status
Enabled/ Disabled.
7.5.2 Associated Clients
The administrator can remotely oversee the status of all associated clients on this page. When a low SNR
is found here, the administrator can tune the corresponding parameters or investigate the settings of
associated clients to improve network communication performance.