User's Manual

VTC 6110 User Manual

Chapter 1: Product Introduction

Power Management

Power-on delay time is selectable by BIOS to disable and enable in 10sec •

/ 30sec / 1min / 5min / 10 min / 15min / 30min / 1hr.

Power-off delay time is selectable by BIOS to disable and enable in 20sec •

/ 1min / 5min / 10min / 30min / 1hr / 6hr / 18hr.

S3, S4 suspend mode•

•IgnitionOn/OffstatusdetectablebySW

•LowbatterystatusdetectablebySW

Ignition enable/disable is jumper selectable•

Shut down system automatically when the system’s internal temperature •

is over 80C.

VTC 6110 will automatically shut down 5 minutes after the duration •

of low battery voltage is over 60 sec. User can detect this situation via

software.

If the ignition is off and the system is still on after 3 minutes, VTC 6110 •

will shut down automatically.

If the ignition is off, the user can detect this status via the software. •

If the ignition is turned on again and the power-off delay is in progress, •

VTC 6110 will cancel the delay function and will continue to operate

normally.

If the ignition is turned on again and the power-off delay ended, VTC •

6110 will shut down completely will power-on again automatically.

If the ignition is turned off again and power-on delay is in progress, VTC •

6110 will cancel the delay and stay in power-off status.

If the ignition is turned off again and the power-on delay ended (en-•

tered OS already), VTC 6110 will continue to operate normally.

If the ignition is turned off again and the power-on delay ended (in BIOS •

process), VTC 6110 will shut down immediately.

If VTC 6110 is off, only below 10mA is used.•