User's Manual

Copyright © 2009 NEXCOM International Co., Ltd. All Rights Reserved.
6
VTC 6110 User Manual
Chapter 1: Product Introduction
2. Mode B. When the ignition is from “low” to “high”, you can turn on
VTC 6110 only by pressing the power button. When the ignition is
“high”, you can press the power button to turn on/off VTC 6110.
If the ignition is from “high” to “low”, VTC 6110 will turn off automati-
cally. When the ignition is “low”, pressing the power button will not
turn on VTC 6110.
Normal PC Mode
3. Mode C. When there is power input, you can turn on VTC 6110 only
by pressing the power button. Ignition signal will not power on/off VTC
6110.
4. Mode D. When there is power input, VTC 6110 will turn on automati-
cally. Ignition signal will not power on/off VTC 6110.
Startup and Shutdown Mode (Refer to SW5 setting)
The start up and shut down setting modes are as follows.
1. Mode A (default setting). When the input power voltage is 12V, use
SW5 to select this voltage. Use the BIOS to select the start up and shut
down voltages.
2. Mode B. When the input power voltage is 24V, use SW5 to select this
voltage. Use the BIOS to select the start up and shut down voltages.
3. Mode C. The working input power voltage is 6V~36V. Start up and shut
down voltages settings are disabled. When using external battery kit
(VTK33B), mode C setting is required.
Power Button
There are 4 types of power on/off mode. Use JP1 and JP2 to select a mode.
(refer to the Internal Jumpers and Connectors section for details).
Vehicle PC Mode
1. Mode A (default setting). When the ignition is from “low” to “high”,
VTC 6110 will turn on automatically. When the ignition is “high”, press
the power button to turn on/off VTC 6110.
When the ignition is from “high” to “low”, VTC 6110 will turn off auto-
matically. When the ignition is “low”, pressing the power button will
not turn on VTC 6110.
Physical Features
Front Panel
GPRS/UMTS/HSDPA module
antenna mounting holes
WiFi/Bluetooth module
antenna mounting holes
Power button
LEDs
USB
Reset button
SIM card socket
Line-out
Mic-in