User Manual

WARNING: Use caution while cleaning
the condenser as the edges of the fins are
sharp.
Water pipe

In order to ensure food safety, the water
pipe of the ice machine should be cleaned
regularly.
Wintering

Turn off the water and power supply, drain
the residual water from the water trough,
inlet pipe and drain pipe.
The maintenance of the ice machine is
not covered by the manufacturer's
warranty!
Clean Function
NOTE: Empty the bin of ice in
advance.
NOTE: Clean and sterilize the bin and
rinse completely.
NOTE: Clean and sterilize the ice
sliding board, water distribution pipe,
water supply pipe, water pump, and rinse
completely.
 Turn the ice maker on; press and hold
the “CLEAN” button for 3 seconds, the
ice maker will enter clean mode. Add
cleaning solution manually and follow the
cleaning and sterilizing process
instructions.
 Press “CLEAN” button. The ice maker will
do auto clean for about 15 minutes.
When complete, the LED display will
flash “Clean”.
 Add sterilizing solution manually and
follow the cleaning and sterilizing
process instructions. Press the “CLEAN”
button again; the ice maker will enter an
auto-sterilizing mode for about 15
minutes. When complete, the ice maker
will enter a 5 cycle rinsing process.
 Once the cleaning process is complete,
the ice maker will return to standard ice
making mode.
 Discard the next 5 batches of ice.
Service Call
If the ice machine works abnormally, confirm
below before making a service call:
1. Check the water supply:
✔ whether there is water in the water
trough;
✔ whether the water pressure for the ice
machine is 1.3 Bar to 5.5 Bar; the water
temperature is 41-95°F (5-35 °C);
✔ whether the water valve is open;
✔ whether there is no water leakage;
2. Check the power:
✔ whether the panel display is not
displaying the OFF standby state;
✔ If the LED on the display panel is blank