User Manual

Installation Steps
1. Upon delivery, check if the ice machine
and all accessories are in good condition;
check the machine model and the
machine nameplate.
2. Clean the ice bin and all areas inside with
a sponge soaked in warm water. Then
wash and dry it with potable water.
3. Place the ice machine in the operation
area; ensure that the machine is placed
on a leveled floor. So as to ensure the
water flows evenly on the evaporator.
4. For this air cooled unit, good ventilation is
required. Allow no less than 12” from the
front, 8” from the rear, and 6” from each
side of the unit to the wall.
5. The bottom of the ice machine is
equipped with adjustable legs for level
adjustment and floor cleaning.
6. Connect the machine's inlet water filter
(not included) and water pipe referring to
the schematic diagram of installation; if
the installation site is already equipped
with a drinking water system, a water
filter may not be required.
NOTE: Filter not included.
NOTE: The filter flow direction should
be correctly installed as per the direction
marker on the filter head cover or filter.
NOTE: This machine is to be used
with inlet water filter (not included). The
filter will keep impurities from the water
used as the machine is running.
Generally, filters should be replaced
every month to 3 months depending on
usage.
7. Connect the machine to the water supply
using the 3/8" inlet pipe supplied with the
machine. It is recommended to install a
water valve (not supplied with this
machine) on the water supply line.
8. Make sure the drain pipe is not blocked
with foreign debris, and then connect it to
the drain connection. It is recommended
that the drain pipe be connected to an
open drainage port.
9. Any joint in the drain pipe must not be
higher than the machine drainage port;
and cannot be higher than the previous
joint.
10. Confirm the power requirements stated in
the machine nameplate; ensure that the
power supply meets the requirements.
11. A circuit breaker or switch with leakage
protector and reliably grounding is
required.
12. Turn off the switch on the power line and
connect the machine to the power
source.