User Manual

Startup and Operation
1. Before you start up the machine, check
and confirm:
• That the packaging tape inside the ice
machine has been removed;
• All accessories and items in the ice bin
have removed;
• The ice machine has been adjusted to a
leveled state;
• The water pipe has been connected and
the water valve is open;
• The plug has been connected to the
power supply and the power switch is off;
• The ambient temperature, water
temperature, and pressure of the water
supply meet the above requirements.
2. Start up: turn on the power switch. After
the machine is powered-on, it will
automatically being to make ice.
3. For normal operation, check and confirm:
✔ There is water in the water trough and no
overflow occurs;
✔ The pump is working properly and water
is flowing evenly on the evaporator;
✔ The compressor is running normally, the
temperature of the evaporator and the ice
making water is gradually decreasing;
✔ For air cooled machine, check that the
fan is running normally, and there is
stable air flow in the inlet and outlet of the
ice machine;
✔ The ice machine has no abnormal noise;
✔ The ice machine has no abnormal
vibration;
✔ It takes about 10 to 20 minutes to make
one batch of ice, depending on the
ambient temperature and the
temperature of the water. The higher the
temperature is, the longer the ice making
will take.
Operation Instruction
• Startup: after proper installation, connect
the water source and turn on the power
supply, the machine will start working.
Note: If the ice machine will not be
used for a long time, disconnect the
power and water source.
• Self-Check: Once powered on for the
first time, the ice maker will do a self-
check and pump out remaining water.
• Preparing: After the ice machine is
energized, the inlet valve will open and
water will enter the machine.
• Ice Making: After pre-cooling for
approximately 30 seconds, the water
pump will start, and water will flow
through the evaporator smoothly and
evenly, the ice cubes are gradually
formed in the ice cube tray.
• Ice Harvest (Drop): After the ice making
process, the water pump will turn off,
and the defrost valve will turn on,
allowing hot gas to enter the evaporator.
The ice cubes slide from the evaporator
into the ice bin.
WARNING: Keep hands away from ice
bin during the harvest process, to prevent
injury or contamination.
• Shutdown: The ice maker will stop
working when you click the “on/off” button
on the panel during running process.
• Full Bin Auto-Stop: Once the ice bin is
filled to a predetermined height, the
sliding board cannot reset and the ice
maker will automatically stop. Once ice
has been removed, the ice maker will
turn back within a few seconds.