User Manual

Fault Codes:
Code
Comments
Work Mode
E01
Water Curtain or Ice
Full Switch Fault
Sleeping mode
and recover after
the water curtain
is reset
E03
Ice Harvest Overtime
Sleeping mode
E04
High Temp. Fault
Sleeping mode
E05
Water Shortage Fault
Sleeping mode
and retry every 30
mins
E06
Over-Pressure Fault
Sleeping mode
E07
Cond. Temp. Sensor
Open Circuit Fault
Keep working
E08
Cond. Temp. Sensor
Short Circuit Fault
Keep working
E09
Water Temp. Sensor
Open Circuit Fault
Keep working
E10
Water Temp. Sensor
Short Circuit Fault
Keep working
E13
Water Level Control
Fault
Sleeping mode
Maintenance
NOTE: Maintenance must be done by
qualified professional personnel.
WARNING: Shut off the power supply
and water source before cleaning or
performing any maintenance.
Exterior Cleaning
 Frequently clean the environment around
the ice machine to keep it clean. DO NOT
block the vents.
 The outer enclosure should be cleaned with
a mild detergent and then wiped clean. If
necessary, use commercial stainless steel
cleaners and polishes.
NOTE: Stainless steel may rust
without proper maintenance.
Inlet Water Filter (not included)
 The filter element should be inspected
regularly. It is recommended to replace filter
element every month to every 3 months
depending on usage.
Interior Cleaning
 The inside of the ice storage bin can be
washed directly with water.
NOTE: Check and confirm the water
pressure is lower than the maximum
allowed pressure. DO NOT flush the part
above the water pump or the evaporator
directly for water protection.
Condenser

For the air-cooled ice maker, the condenser
should be cleaned every three weeks.
Clean using a soft brush or a vacuum
cleaner with a brush attachment.

The condenser filter should be cleaned
every 2 weeks.