ON-SITE RIGGING GUIDE V2.
SAFETY FIRST Read User Manual before deployment. Before use of enclosed speaker system, please ensure that anyone involved in system deployment understands the rigging safety rules as described in the speaker system User Manual. Failure to do this exposes people to potential injury or death. NS-1 is a dedicated calculation software that will give you vital information on your coverage, but also your load limitations, rigging, and mechanics. DO NOT PROCEED if you have not run NS-1 prior to implementing STM.
STM RIGGING PARTS STT-XBOW Single Column top rigging STT-XCOUP2 2 column top coupling bar STT-XCOUP3 3 column top coupling bar STT-MBEAM 2 & 3 column flying beam STT-KBEAM Kelping Beam STT-PTILT Front/Rear Motor Rig point STT-MLINK Center Motor rig point STT-BTBUMPER Single column bottom rigging STT-BCOUP2 2 column bottom coupling bar STT-BCOUP3 3 column bottom coupling bar SST-DPLATE Delta Plate for horizontal aiming VXT-BRIDLE23 Bridle for Single Motor point rig VXT-LEVA750 VXT-LEVA1500 Leva-L
FLYING MODES There are 6 flying modes that can apply depending on design and motor variables: - 2 modes in single motor - 4 modes in double motor. Below table describes these modes and lists parts required.
CLUSTER CONFIGURATION STM rigging hardware allows to fly single column clusters, as well as double and triple column clusters.
CONNECTING STM CABINETS Below table describes connection of one STM M46 or B112 to subsequent module. REAR VIEW LEFT VIEW Operation • • • • • • • • • • • 6 Step 1 Lower cabinet into position, aligning side locking slots on both sides of the cabinets. Step 2 Push REDLOCK™ into “LOCK” position. Ensure handle is locked. Check side locking pins are flush to the rigging plates on both sides of the cabinet. Step 3 Slide piston to lower cabinet, and insert quick release pin.
RIGGING PROCEDURE Procedure description • • • • • • • • • • • 2 motors, Kelping beam and Compression Chain Install XBOW on to each top module, lock into place with two spring locks and rear steel pin. If 2 or 3 columns: join XBOW’s together at front and rear with XCOUP2 or XCOUP3 coupling bars, and secure in place with steel pins. Insert MBEAM at the middle of the XCOUP2 or XCOUP3 coupling bars, and secure in place with spring locks.
DISMANTLING De-rigging De-rigging is as simple as following rigging procedures in reverse order: • • • • • • • • • • • • Lower the array slowly, until the array is close to the floor. Release compression slowly, until the array is hanging vertically. Remove the compression chain, BTCOUP2/3 if required, and BTBUMPERs. Remove all speaker cables within reach, without climbing the array. Set all piston taps to the STORAGE position. Position dollies below the bottom module and lock the wheel brakes.
