User's Manual
37
Product, model number: F5010A (FCC ID: ZYPF5010A)
has also been tested against this SAR limit. The highest SAR
value reported under this standard during product
certification for use at the head is 0.783w/Kgand when
properly worn on the body is 1.124w/kg. The device was
tested for typical body‐worn operations
with the back of the
handset kept 1.5cm from the body. To maintain compliance
with FCC RF exposure requirements, use accessories that
maintain a 1.5cm separation distance between the userbody
andthebackofthehandset.Theuseofbeltclips,holdersand
similaraccessoriesshouldnotcontainmetallic
componentsin
its assembly. The use of accessories that do not satisfy these
requirements may not comply with FCC RF exposure
requirements,andshouldbeavoided.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
devicemaynotcauseharmful
interference,and(2)thisdevice
must accept anyinterference received, including interference
that may cause undesired operation. Any Changes or
modificationsnotexpresslyapprovedbythepartyresponsible
for compliance couldvoid theuser’sauthoritytooperate the
equipment.
38
Note: This equipment has been tested and found to
complywiththelimitsforaClassBdigitaldevice,pursuantto
part15oftheFCCRules.Theselimitsaredesignedtoprovide
reasonable protection against harmful interference in a
residential installation. This equip ment generates uses and
can radiate radio frequency energy
and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. Ho wever, there is no
guarantee that interference will not occur in a particular
installation.Ifthisequipmentdoescauseharmfulinterference
to radi o or television reception, which can be determined by
turning
the equipment off and on, the user is encouraged to
trytocorrecttheinterferencebyoneormoreofthefollowing
measures:
‐‐Reorientorrelocatethereceivingantenna.
‐‐Increase the separation between the equipment and
receiver.
‐‐Connect the equipment into an outlet on a circuit
differentfromthat
towhichthereceiverisconnected.
‐‐Consult the dealer or an experienced radio/TV
technicianforhelp.