Notification Manual

8
LAN Monitor Operation
LAN Monitor when enabled will monitor the LAN or
Router connection and alert you when if no longer detects
a connection. LAN Monitor by default is set to the Off
position. Once a LAN or Router Connection is no longer
detected an alarm will sound, in addition the display alert
as below.
Notification Module:
In the event of a Notification Module alert the display will
show as the screen below.
LAN Disconnected Warning:
(For the Wired Internet Module the message below will
display when the LAN Cable is not detected.)
(For the Wireless Internet Module the message 'WIFI' will
toggle when the Module is not connected to a wireless
router).
In addition, the following WIFI Connection Code will also
display. The code will be in a format of Cxx-Sxx.
Cxx – Code; Sxx – Sub Value
Code '00'
Sill performing initial connection attempt.
There is no sub value for this parameter.
Code '01'
Connection Successful
There is no sub value for this parameter.
Code '02'
Connection failed.
Sub values:
'02' – Join Failure
'03' – Authentication Failure
'04' – Association Failure
'05' – WEP Handshake Failure
'06' – PSK Calculation Failure
'07' – PSK Handshake Failure
'08' – AdHoc Join Failure
'09' – Security Mismatch
'10' – No Suitable AP Found
Code '03'
Connection Temporarily Lost
Sub values:
'01' – Beacon Timeout
'02' – Deauth Received
'03' - Disassociate Received
Status Code '04'
Connection Permanently Lost
Sub values:
Same as Status Code '03'
Status Code '20'
Connection timeout.
A timeout occurred attempting connection. Will keep
retrying.
There is no sub value for this parameter.
Status Code '20'
Connected but DHCP is not bound.
There is no sub value for this parameter.
Network Defaults:
IP Address – '192.168.1.105'
IP Mask – '255.255.255.0'
IP Gateway – '192.168.1.10'
DNS – '192.168.1.51'
HTTP Port – '80'
Username: 'NPAdmin' (Case Sensitive)
Password: Unit Serial Number (Case Sensitive)
LAN Problem
ANiMod Problem
LAN Cable Check!
WIFI Check! Cxx-Sxx