Manualshelf

Product Manual

ManualsBrandsNexPump ManualsPlumbingNexpump® Ai Dual-eniw-combination Sump Pump System
17181920212223242526
21
Quick Reference Guide
Power OFF
1. Disconnect Battery
a. Disconnect (+) Positive Cable (Red)
b. Disconnect (-) Negative Cable (Black)
2. Unplug NexPump’s AC Power Cord
Power ON
1. Plug in the AC Power Cord FIRST!
2. Connect Battery
a. Connect (-) Negative Cable (Black)
b. Connect (+) Positive Cable (Red)
c. Verify Battery Reverse Indicator
Manual Override Mode
1. Set Override switch to up position.
2. Pump(s) should turn on.
3. Battery life will not be calculated.
4. Clog or vapor lock detection is disabled.
5. Set Override switch to down position to turn pump(s) off and return to normal.
Clear Alarm(s)
To clear the alarm use the up, down arrows to find the menu clear alarm. To select press ENTER.
Silence Alarm
To silence the alarm use the up, down arrows to find the menu silence alarm (24H). To select press ENTER.
Note: Automatically cleared after 24 hours. Alarm will only silence for 'Pump Activated' and ‘AC Power Problems Alarms
UnSilence Alarm
If the alarm is silenced you can unsilence it by selecting the menu unsilence alarm.
To unsilence the alarm use the up, down arrows to find the menu unsilence alarm. To select press ENTER.
Manual Test
To run a manual self-test use the up, down arrows to find the menu manual self-test. To select press ENTER.
Retrieve Serial Number
The NexPump serial number is located on a card on the top of the unit or a sticker on the rear of the unit.
Battery Amp Hours Setup
1. Use the up, down arrows to find the configuration menu. Select it by pressing ENTER.
2. Wait for the screen ‘Battery Amps?’
3. Use the left and right arrows to increase or decrease the amps. Press ENTER when on correct amps.
Stats Information
The stats can be found under the information menu. Use the up and down arrows to find the information menu. Select it by
pressing ENTER.
Disable Alarm
To disable the alarm use the up and down arrows to find disable alarm (5D). Select it by pressing ENTER. To confirm it use the
left and right arrows until the cursor is over the desired position. Select it by pressing ENTER.
Enable Alarm
If the alarm is disabled you can re-enable it by using the up and down arrows to find enable alarm. Select it by pressing ENTER.
Reset Battery Timer
1. Use the up, down arrows to find the reset menu. Select it by pressing ENTER.
2. Wait for the screen ‘Reset Battery Timer Confirm?’
3. Use the left and right arrows until the cursor is over the desired position. Select it by pressing ENTER.