Installation Guide

24 25
[e-mail]
Video Instruction: bit.ly/nlrbuild
26: Select your height then bolt through the shifter brackets into T-Nuts from step 25
27: Bolt shifter extension plate to the base on the side you have installed T-nuts for your shifter in step 1a or 1b
28: Install 4 x T-Nuts into the inside channel of the shifter support bar (Longest shifter arm from contents page). Slide them
to the bottom of the bar to line up with the bracket from step 27 (Red dots are T-nut placement)
PARTS
4 X M8 16mm bolt
4 X M8 washer
PARTS
4 X M8 countersunk bolt
PARTS
4 X M8 regular t-nut
Note: Shifter arm bracket should
be angled towards the back
Note: Add this plate to the same
side you installed the shifter bracket
30b: Install 1 x T-Nut into each of the channels (highlighted in blue)
30a: Install 2 x T-Nuts into each of the top side channels (highlighted in blue)
29: Bolt through shifter arm bracket into previously installed T-Nuts from step 28
PARTS
4 X M8 16mm bolt
4 X M8 washer
PARTS
2 X M8 regular T-nut
PARTS
4 X M8 regular T-nut
INSIDE VIEW OUTSIDE VIEW
Note: Do not tighten countersunk bolts
until alignment with shifter arm is correct