Car Stereo System User Manual

3
• Disconnect negative battery terminal before starting installation.
Consult the vehicle’s owner’s manual for proper instruction.
• The unit is designed for a 12Volt DC negative ground operation
system only. Before installing the unit, make sure your vehicle is a
12Volt DC negative ground system.
• Be sure to connect the color coded leads according to the diagram.
Incorrect connections may cause the unit to malfunction or damage
the vehicle's electrical system.
• Be sure to connect the negative (-) speaker leads to the negative
(-) speaker terminal. Never connect negative (-) speaker leads to
chassis ground.
• The unit is only designed for use with 4 speakers. Do not combine
output for use with 2 speakers. Do not ground negative speaker leads
to the chassis ground.
• Make sure all the connections are completely correct before turning on
your unit.
• When replacing the fuse(s), the replacement must be of the same
amperage as shown on the fuse holder.
• Do not block vents or heater panels. Blocking them will cause heat
to build up inside and may result in fire.
• After completing the installation and before operating the unit, recon-
nect the battery. Then press the (RES) button with a pointed object,
such as a ball-point pen to set the unit to its initial status.
Tools for Installation
• 2 removel wrenches are supplied for taking out the old unit and place
with this brand name car radio. The following tools and supplies may
also be needed for the installation:
Tools for Installation:
- Philips Screw-drivers
- Wire Stripper
- Wire Cutter
- Hammer
- Pencil
- Electrical Tape
- Electric Drill
Supplies for Installation:
- Machine Screws
- Crimp Connectors
- 14 Gauge Wire for Power
Connections
- 14-16 Gauge Speaker Wires
* The above are not supplied.
3
Notes on Installation