Important Safety Instructions ， CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USE-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric to persons.
Important Safety Instructions NOTES 1) Read these instructions. 2) Keep these instructions. 3) Heed all warnings. 4) Follow all instructions. 5) Do not use this apparatus near water. 6) Clean only with a damp cloth. 7) Do not block any of the ventilation openings. Install in accordance with the manufacturer's instructions. 8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
Important Safety Instructions Warning Failure to avoid the following potentially hazardous situations may result in injury or property damage. The unit is designed to provide you with route suggestions. It does not reflect road closures or road conditions, traffic congestion, weather conditions, or other factors that may affect safety or timing while driving. Use the unit only as a navigational aid.
Important Safety Instructions Note: This equipment has been tested and found to comply with limits for Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Accessories Accessories List ITEM NAME QTY Instruction Manual 2 AC Adaptor 1 Car Adaptor 1 Mounting Bracket 1 USB Cable 1 Mounting Cradle 1 Stylus 1 Dashboard Mount Disk 1 SD Card 1 Pouch 1 NOTE Accessories and their part number are subject to modification without prior notice due to improvements.
Contents Important Safety Instructions …………………………………..……..…..1 Accessories ……………………………….……….…....5 View of Main Unit ……………………………….………..…...7 System Connections ………………………………..…………....8 Power supply Preparation ……………………………….…….….….10 General Setup …………………………….……….….….12 Playing Music ……………………………….……….…..17 Photo Viewer …………………………….……………...19 Use of the Mount Accessories ……………………………….……….…..22 Troubleshooting ……………………………….……….…..23 Specifications ……………………………….……….…..
View of Main Unit 1. POWER Button Press for a longer time to enter or exit the standby mode. 2. Card Slot Insert the SD card into the slot. 3. Earphone Jack Connect earphone for private listening. When the earphone is connected to this jack, the speaker will be turned off automatically. 4. USB Port Connect to the supplied adaptor to charge the unit. Used to connect to the USB device. 5. LCD Screen 6. Stylus Finger touches the screen directly or use the touch pen included for optional. 7.
System Connections z Always ensure that the unit and any other external device connected to the unit are switched off and unplugged from the power supply before you attempt to connect the unit to any external device. Inserting SD Card The unit is designed with an SD Card slot which allows you to insert an SD card into the unit as shown below: To remove the card, gently press the card in with your fingernail. The card unlocks and protrudes slightly. You can now remove the card.
Power Supply Preparation Using the AC Adaptor The unit is supplied with an AC adaptor for powering and charging its battery. 1. Connect AC adaptor to the left side of the unit in the USB port, as shown on the right. 2. Plug the two-prong end of the power cord into a grounded electrical outlet. Note: ¾ Turn unit's power off before unplugging. ¾ When using the adaptor, the LCD screen will be brighter than with the rechargeable battery.
Power Supply Preparation About Rechargeable Battery Your portable GPS device comes with a built-in rechargeable battery. Charge the battery fully before initial use. Charging time is normally about 3.5 hours. A fully charged battery delivers about 2 hours of use. Working conditions and precautions for the rechargeable battery ¾ New batteries should be fully charged before initial use. ¾ Battery should only be used and charged when temperatures are between 32°-100°F.
General Setup System Main Menu When in navigation mode, Tap MENU button, and then choose SETTINGS. In the SETTINGS menu, tap EXIT, a confirmation message appears. Tap Exit in the confirmation message to return to the system main menu, as shown below. In the main menu, there are four items for selecting. Touch the corresponding item to enter. Tap to enter the Navigator. Tap to enter the MP3 Player. Tap to enter the Photo Viewer. Tap to enter the Setup menu.
General Setup Setup Menu In the main menu, tap In the Setup menu, tap to enter the Setup menu, the screen will display as below: to return to the main menu. Language Tap in the Setup menu to enter Language setting menu for language selection, as shown below: Tap , Then tap buttons to select language. to confirm or tap to cancel.
General Setup Date & Time Tap in the Setup menu to enter Date & Time setting menu for changing to the current time zone, date and time, as shown below: buttons to select the proper Time Zone. Tap the Tap the buttons of Date group to change the corresponding date. Tap the buttons of Time group to change the corresponding time. to confirm or tap Then tap to cancel.
General Setup Volume Tap in the Setup menu to enter Volume settings menu for volume adjustment, as shown below: Tap the to decrease the volume. Tap the to increase the volume. to confirm or tap Then tap to cancel. Align Screen Tap in the Setup menu to align the screen, as shown below. Tap the center of the cross with your finger or stylus. When the cross moves to another position, tap and hold the center of the new target. Repeat each time to complete the calibration process.
General Setup Power Tap in the Setup menu to enter Power menu, as shown below: The Power menu displays the unit’s battery status. The values are between 0% and 100%, where 0% means the battery power has run out completely, and 100% represents a full battery power. When the battery is being charged, the Battery Status will be “Charging”.
Playing Music The unit is designed with an SD card slot and supports MP3 and WMA format files playback. To use the music player, you will need to have an SD card with your MP3 music files preloaded. Please note that you cannot use the navigation function of the device at the same time you are using the music player. Remove the mapping software SD card that comes with the device from the SD card slot on the side of the unit. Then insert your SD card with your MP3 or WMA music files.
Playing Music button to enter the music play list menu, as shown below: Tap When you open the play list, the system will look for audio files on its SD memory card and create a play list automatically. If the play list consists of more than one screen, tap the up arrow for the previous page and the down arrow for the next page. / toggle buttons to determine whether the player will repeat the songs in Tap the play list or not. / Tap randomly.
Photo Viewer The unit is designed with an SD card slot and supports JPEG format files playback. To use the Photo Viewer, you will need to have an SD card with your JPEG picture files preloaded. Please note that you cannot use the navigation function of the device at the same time you are using the Photo Viewer. Remove the mapping software SD card that comes with the device from the SD card slot on the side of the unit. Then insert your SD card with your JPEG picture files.
Photo Viewer In the folder menu, double tap the memory card icon, and the photos stored in the memory card will be listed on the screen. In the photo list, double tap a photo to play it on the LCD screen. You can also tap a photo to select it and then tap to play it. Tap to return to the previous menu. Tap to enter the Setting menu for setting the Slide Show, as shown below. You can set the slide show on or off to determine whether or not to play photos in slide mode.
Photo Viewer When playing photos, the Photo Viewer has following playback features: Tap to go back to the previous photo; tap to rotate the photo. Tap Tap to switch to the next photo. , to zoom in or out of the photo. to play the photo in full-screen mode; double tap the screen again to return to Tap Photo Viewer. Tap to return to the photo list.
Use of the Mount Accessories When using the unit in vehicle, you can use the supplied mount accessories (mount bracket, mount cradle and dashboard mount disk) to mount the unit in the vehicle. Take the following steps to operate: Fig. 1 1. 2. 3. Fig. 2 Fig.3 See Fig. 1 Follow arrow 1 - slide the mount cradle to fix it to the mount cradle See Fig. 2 Set the bottom edge of the unit onto the mount cradle. See Fig. 3 Fix the unit on the mount cradle, then press the suction cup to the windshield .
Troubleshooting Take steps described in the tables below to solve simple problems before contacting customer service. If you suspect something is wrong with this unit, immediately turn the power off and disconnect the power connector from the unit. Never try to repair the unit yourself because it is dangerous to do so. PROBLEM User can’t turn the unit on. There is no sound. Dim screen. The unit can’t receive satellite signals or can’t orient.
Troubleshooting PROBLEM The unit can receive signals now but can’t then or signals received are not stable. POSSIBLE CAUSE POSSIBLE SOLUTION The built-in rechargeable battery is weak. Use the adaptor to supply power or charge the battery. The unit may be obstructed by veil, such as heat insulation paper. Remove the veil. Swing of the unit is too great. Avoid great swing of the unit. System software of the unit fails to function after a change. Turn the unit on again.
Specifications TFT screen size 4.3 inches Frequency Response 20Hz - 20kHz Audio Signal-to-noise Rate ≥65dB Audio distortion+noise ≤-20dB (1kHz) Channel Separation ≥70dB (1kHz) Dynamic Range ≥80dB (1kHz) Power AC 100-240V ～ 50/60Hz ; DC 5V Power Consumption < 8W Dimensions 123mmX80mmX20mm (L*W*D) Weight About 0.17Kg Design and specifications are subject to change without notice.
© 2008 Nextar (Hong Kong) Limited. Nextar is a trademark and service mark of Nextar (Hong Kong) Limited. All other brand names, trademarks and service marks are property of their owners. Nextar may find it necessary to modify, amend or otherwise change or update this manual. We may reserve the right to do this at any time, without any prior notice. All specifications and features are subject to change without notice. www.nextar.com Or write us at: Nextar Inc. 1661 Fairplex Dr.
