Owner's Manual
Table Of Contents
@)
Select the required
Fuse
Tap
Cable from
the
two supplied types. This depends on
whether
the
original fuse was
of
the larger
ATO/C
or
smaller
ATM
type. The 2 Amp fuse required
to
protect
the
Dash Cam
is
already installed within the Fuse
Tap
Cable and should
NOT
be changed. Insert the
original fuse from the vehicle in to the available
location upon the Fuse
Tap
Cable, this will be the
'original fuse location',
as
shown overleaf. Now
insert the Fuse
Tap
Cable in
to
the fuse box, at the
position where the original fuse was removed from,
as
noted
in Item 1.2, overleaf.
Note
: If the fuse removed from
your
vehicle
is
a Micro
(low profile mini) fuse type, then you can still use the
ATM
(Mini) fuse tap cable.
You
will however need
to
source yourself
another
ATM
(Mini) fuse,
of
the same
,·ating
as
the fuse
that
you removed originally. Place
the new
ATM
(Mini) fuse into the 'original fuse
location'. At this stage,
if
you have a multi-
meter
, you
can check for 12-24Vdc at the end
of
the Fuse Tap
Cable. A voltage should only be present when the
vehicle's ignition
is
turned on (or connected
to
a
permanent
live).
Ther·e
is
also an
LED
on the
regulator housing
to
indicate
if
the Fuse
Tap
Cable
has been wired correctly (see next page).