Owner's Manual
Table Of Contents
to loosen any
trim
and hide the cable
as
necessary.
Make sure there
is
still sufficient cable available
to
connect
to
the
Dash
Cam,
when installed correctly
upon it's windscreen mount.
2_!..;
Continue
to
route the cable towards the
fuse box. Once close
to
the fuse box, take the black
wire (negative) from the
Car
Power Cable and find a
suitable position
to
attach the spade connector to
the vehicle bodywork. Normally a screw can be
removed and refitted
with
the spade connector
underneath.
Take
the red wire (positive) from the
Car Power Cable and locate
the
red bullet
connector at the end. This plugs directly in
to
the
female bullet connector
of
the
Fuse
Tap
Cable.
~
Tidy any excess cable using cable clips and secure
the cable
to
a convenient location to prevent rattles.
Replace any removed
trim
from the vehicle and the
fuse box cover,
as
required.
@ A Ferrite Core
is
supplied with the Hardwire
Kit.
This can be used to suppress any interference which
may be heard upon
FM
or
DAB
radio. Clip
the
Ferrite
Core
to
the
Camera Power Cable at a distance
of
approximately 20cm from the camera
for
best
effect,
if
required.