Operation Manual

Primary DNS
Secondary DNS
,
Nextbase @Gallery 15 - User s Guide
3. Navigate to Enter Manually, and press OK to confirm.
2008/1/1 7
02:45
2008/1/17 02:45
Change Settings
Scan for wireless networks
Change Settings
SSID
Wi-Fi Network Wi-Fi Network
Enter Manually
Security
IP address and DNS
None WEP WPA
Dynamic Static
Enter Manually
IP Address
Subnet Mask
Gateway
Connect
Navigate to SSID, press OK to bring up the virtual keyboard, and enter the SSID address by
using the virtual keyboard.
Navigate to Security, and press OK to navigate from None, WEP, WPA. Select one to match
your Wi-Fi routers security method.
Navigate to IP address and DNS, and press OK to select between Dynamic and Static.
If Dynamic is selected, the information above will turn into grey.
If Static is selected, the information above will turn into white.
When Static is selected, scroll down to IP Address and press OK to pop up the virtual
keyboard to fill in the numbers.
After Secondary DNS is filled, the cursor will jump to Connect, and press OK to finish the
operation.
Note:
The IP address consists of 4 sections. The number range of each section is 0-255. If a number
over 255 is entered, it will be automatically changed to 255. Once the third digit of a section is
entered, the cursor will move to the next section automatically.
4. If the IP/DNS information is wrong, the message below will pop up.
2008/1/1 7
02:45
Can not connect to Picasa,
please check the IP address
and DNS
Setup 33