Operation Manual

DRIVING RECORDER PLAYER SOFTWARE INSTALLATION

System Minimum Requirements:

Pentium III 500 MHz or Celeron at 800 MHz.

1 Gb RAM.

500 Mb hard drive space.

CD-ROM Drive (tray loader only)

1024 x 768 monitor display

How to install:

With disk inserted in to the CD drive, navigate to the disk using windows explorer and display the disk contents.

· Driving Recorder Player MPH Software (V2.0)

This is the folder which holds the required installation files.

· NBDVR302G Driving Recorder Player Installation Guide (UK Version A1)

This document explains the installation process of the Driving Recorder Player

· NBDVR302G Instruction Manual (UK Version A1)

Open the folder called ‘Driving Recorder Player MPH Software (V2.0)’ and run the 'setup.exe' file and follow the

on-screen instructions.

For additional instructions please refer to the ‘NBDVR302G Playback Software Installation Guide (UK Version)’

supplied on the disk.

Windows XP, Vista, Windows 7, Windows 8

Electronic copy of this instruction manual

Should your PC not have a CD Drive, then please visit our website

to download an electronic copy of the installation instructions and setup file.

Note:

· Do NOT insert disk into you PC if it uses a ‘slot loader’, this will cause damage to your PC which is not covered

under the iN-CAR CAM manufacturers warranty.

· For some operating systems the installation process may vary.

http://nextbase.co.uk/pages/Downloads.html

This section will guide you through the installation of the Driving Recorder Player software, designed to enable the

viewing of recorded files as well as checking journey route / GPS data (location and speed) and G Sensor information.

Please see following pages for guide on using the Driving Recorder Player.

English