Operation Manual

6. G Sensor

Adjust the sensitivity of the G Sensor, it is the G Sensor that detects forces which will

automatically protect the video recording in event of a collision.

Default Setting: Normal

Note:

- Should the G Sensor be triggered by an collision, then the recordings (3 minute file length

as default) are very valuable and the video files become protected as follows:-

1. The G Sensor is triggered within the early part of the video clip then the current and

previous recordings become protected. (Capturing the build up to the incident)

2. The G Sensor is triggered in the middle of the video clip then the current recording

becomes protected.

3. The G Sensor is triggered within the latter part of the video clip then the current and next

recordings become protected. (Capturing what happened next)

7. TV Frequency

Set the AV output frequency as required.

Default Setting: 50Hz

8. Speed Stamp

Turn On / Off the Speed stamp shown on recorded files.

Default Setting: On

9. Speed Units

Select required units of speed, KMH or MPH.

Default Setting: MPH

10. NEXTBASE Stamp

Turn On / Off the NEXTBASE stamp shown on recorded files.

Default Setting: On

11. Rotate Display

Rotate the display and recorded file by 180°, this allows the iN-CAR CAM to be mounted on

the dashboard. Please contact your local Nextbase dealer to purchase the correct mount.

Default Setting: Off

Note:

- The button functions do not rotate.

12. Timezone / DST

The Time and Date is automatically set from the satellite signal, but can be adjusted

dependant upon your Time Zone (country) or whether Daylight Savings Time (DST) is

operational.

Default Setting: GMT

GENERAL SETTINGS MENU (CONTD.)